Development and Validation of a Robust and Efficient HPLC Method for the Simultaneous Quantification of Levodopa, Carbidopa, Benserazide and Entacapone in Complex Matrices

Authors

  • Erik Wollmer Department of Pharmacy, Institute of Biopharmaceutics and Pharmaceutical Technology, University of Greifswald, 17489 Greifswald, Germany
  • Sandra Klein Department of Pharmacy, Institute of Biopharmaceutics and Pharmaceutical Technology, University of Greifswald, 17489 Greifswald, Germany

DOI:

https://doi.org/10.18433/J3K923

Abstract

Purpose: A variety of fixed-dose combination products is used in the therapy of Parkinson Disease. However, to date a proper analytical method applicable for comparative screening of different antiparkinson products was not available. The objective of the present work was thus to develop and validate an analytical method for the simultaneous quantification of levodopa, carbidopa, benserazide and entacapone. The method should be applicable for quantifying samples from drug release experiments with marketed products and prototype formulations performed under compendial and biorelevant test conditions. Methods: A fast and robust method applicable for separation and quantification of the four compounds was developed and validated according to International Conference on Harmonization guidelines. Method validation covered applicability to a wide concentration range of all compounds and peak separation in complex sample matrices such as biorelevant dissolution media. Results: The compounds were successfully separated by using a gradient elution method on an endcapped LiChrospher 100 RP-18 (250 x 4.6 mm, 5 µm) column coupled with a LiChrospher 100 RP-18 precolumn (4 x 4 mm, 5 µm) at a column temperature of 35.0 °C and a flow rate of 1.50 mL/min. The injection volume was 30 µL and the detection wavelengths were 280 and 210 nm, respectively. For all drug/media combinations the method was linear (r2 > 0.999) for a concentration range corresponding to 1.25 - 125 % label claim (i.e. 200 mg levodopa/entacapone and 50 mg carbidopa/benserazide) released. All other validation parameters were in the specified limits over the same concentration range. Conclusion: The new method allows for robust and fast separation of levodopa, carbidopa, benserazide and entacapone without any interference caused by excipients or ingredients of compendial and biorelevant dissolution media and thus presents a valuable tool in both formulation development and in vitro drug release screening of numerous fixed-dose combinations of antiparkinson drugs.

 

This article is open to POST-PUBLICATION REVIEW. Registered readers (see “For Readers”) may comment by clicking on ABSTRACT on the issue’s contents page.

Downloads

Download data is not yet available.

Downloads

Published

2017-07-27

How to Cite

Wollmer, E., & Klein, S. (2017). Development and Validation of a Robust and Efficient HPLC Method for the Simultaneous Quantification of Levodopa, Carbidopa, Benserazide and Entacapone in Complex Matrices. Journal of Pharmacy & Pharmaceutical Sciences, 20, 258–269. https://doi.org/10.18433/J3K923

Issue

Section

Pharmaceutical Sciences; Original Research Articles